|
Features
and benefits...
*
Support
sleeve located in main nut assembly reduces "pull
back" during installation
*
Back nut
radius allows smooth transition of heat shrink tubing
*
Visible
entry of center conductor into seizing mechanism (no blind
entry)
* Unique
actuator closing mechanism preserves reusability
* Flush
insulator prevents moisture from collecting or migrating
along the path
* Non-rotational
design for installation and disassembly
* Brass
pins with bright acid tin plating for excellent RF
conductivity
Ordering
information
Please refer to
our Internet catalogue for specific item numbers or call the nearest
Corning Cabelcon distributor or sales office.
Link
to G2 connectors
|
GRS
series 3-piece trunk and distribution connectors
Trunk and Distribution connectors are used in low power RF,
video, data signals and system power broadband systems.
Chassis mounting connectors are used in 5/8
24 equipment entry through independent seizing of the center
conductor, the installer can verify the center conductor has
been seized prior to tightening the back nut.
Placement of the integral mandrel of the
connector in the main nut provides a full view of the center
conductor’s entrance into the seizing mechanism and requires
minimal pull back for ease of installation.
The GRS connectors have a center conductor
cutting guide and are reusable.
|
|
Connector
Specifications...
Bandwith:
5 MHz to 1 GHz
Operating
Range:
-40º C to +60º C
Nominal
Impedance:
75 Ohms
Shielding
effectiveness:
> 130 dB
Return
Loss:
- 30 dB minimum
Insertion
Loss
< 0.12 dB (pin types)
Cable
retention:
Exceeds cabel
manufacturers
maximum pulling tension
specifications |
